Advertisement
Immobilizer Control System Check
Step
1
1) Start the engine.
Is it possible to start the engine?
2
1) Check behavior of immobilizer indicator lamp (1) by
turning the ignition switch to ON position.
Does it flash ON and OFF continuously?
Diagnostic Trouble Code (DTC) Check
NOTE:
To know how to use SUZUKI scan tool in
detail, refer to its operator's manual.
1) Turn the ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located under instrument panel at driver's
seat side.
Special tool
(A): SUZUKI scan tool
1
3) Turn the ignition switch to ON position.
4) Check if any DTC is stored in ECM according to the
instructions displayed on SUZUKI scan tool.
5) After completing the check, turn ignition switch to
OFF position, and then disconnect SUZUKI scan
tool from DLC.
Diagnostic Information and Procedures
Action
1
S4RS0AA304002
(A)
I4RS0AA30005-
Immobilizer Control System:
Yes
Immobilizer control
system is in good
condition.
Check what diagnostic
trouble code (DTC) is
detected by ECM
referring to "Diagnostic
Trouble Code (DTC)
Check: ". Then, perform
the troubleshooting
referring to the
corresponding flowchart
in this section.
I4RS0AA30004-
Diagnostic Trouble Code (DTC) Clearance
NOTE:
To know how to use SUZUKI scan tool in
detail, refer to its operator's manual.
1) Turn the ignition switch to OFF position,
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located under instrument panel at driver's
seat side.
Special tool
(A): SUZUKI scan tool
1) Turn the ignition switch to ON position.
2) Clear DTC(s) according to the instructions displayed
on SUZUKI scan tool.
3) After completing the clearance, turn the ignition
switch to OFF position, and then disconnect SUZUKI
scan tool from DLC.
S4RS0AA304001
No
Go to Step 2.
Perform "Engine and
Emission Control
System Check: in
Section 1A".
S4RS0AA304027
(A)
1
I4RS0AA30005-
10C-5
Advertisement
