Advertisement
Glass / Windows / Mirrors
Rear End Door Window Defogger System Description
The rear end door window defogger is controlled by BCM. For the BCM description refer to "BCM General Description:
in Section 10B".
Windshield Construction
The windshield is installed by using a special type of adhesive (that is, one component urethane adhesive used with
primer). For the windshield replacement, it is important to use an adhesive which provides sufficient adhesion strength
and follow the proper procedure.
1. Windshield glass
2. Windshield molding
CAUTION:
• Described is the glass replacement by using 3 types of primers and 1 type of adhesive made by
YOKOHAMA (one component urethane adhesive to be used with primer in combination). When
using primer and adhesive made by other manufacturers, be sure to refer to handling instructions
supplied with them. Negligence in following such procedure or misuse of the adhesive in any way
hinders its inherent adhesive property. Therefore, before the work, make sure to read carefully the
instruction and description given by the maker of the adhesive to be used and be sure to follow the
procedure and observe each precaution throughout the work.
• Should coated surface be scratched or otherwise damaged, be sure to repair damaged part, or
corrosion may start from there.
Use the specific adhesive which has the following property.
Glass adhesive shearing strength
40 kg/cm
2
(569 lb/in
2
) or more
Adhesive materials and tools required for removal and installation.
• One component urethane adhesive and primers used in combination (For one sheet of windshield).
– Adhesive (470 g (15.7 oz.))
– Primer for glass (30 g (1.0 oz.))
– Primer for body (30 g (1.0 oz.))
– Primer for molding (30 g (1.0 oz.))
• Eyeleteer
• Piano string
General Description
1
5
4
4
3
3
3. Windshield glass stopper
4. Spacer
Glass / Windows / Mirrors:
2
5
4
5. Windshield side garnish
: Do not reuse.
9E-1
S4RS0A9501002
S4RS0A9501001
I4RS0A950001-
Advertisement
