Advertisement
9C-15 Instrumentation / Driver Info. / Horn:
11) Remove instrument panel mounting screws (1).
12) Detach instrument panel from steering support
member (2) and then remove foot duct (3).
2
1
13) Disconnect instrument panel harness connectors,
heater control cables and antenna cable instrument
panel removal.
14) Remove steering column mounting nuts referring to
"Steering Column Removal and Installation: in
Section 6B".
15) Remove instrument panel ground wire.
16) Remove instrument panel mounting bolts (1).
17) Remove instrument panel (2) with steering support
member (3) and instrument panel harness.
1
3
Installation
Reverse removal procedure noting the following.
• When installing each part, be careful not to catch any
cable or wiring harness.
• Tighten instrument panel mounting bolts to specified
torque
Tightening torque
Instrument panel mounting bolt (a): 23 N·m (2.3
kg-m, 17.0 lb-ft)
3
1
I4RS0A930022-
1
2
I4RS0A930023-
(a)
• Tighten steering column mounting nuts referring to
"Steering Column Removal and Installation: in
Section 6B".
• Enable air bag system referring to "Enabling Air Bag
System: in Section 8B".
Information Display Removal and Installation
Removal
1) Remove information display garnish (1) from
instrument panel (2) pulling it arrow direction as
shown.
1
2
2) Remove information display (3) from instrument
panel (2) pulling it in arrow direction shown in figure.
3) Disconnect information display coupler.
2
Installation
Reverse removal procedure.
(a)
I4RS0A930024-
S4RS0A9306019
I4RS0A930032-
I4RS0A930025-
Advertisement
