Advertisement
9D-5 Wipers / Washers:
1
• For motor operation in high speed
a. Connect battery positive (+) terminal to "2"
and its negative (–) terminal to terminal "5".
b. Check if motor revolution speed is as
specification. If check result is not as
specified, replace motor.
Specification
60 – 76 r/min (rpm)
2
• For automatic stop operation
a. Connect battery positive (+) terminal to
terminal "1" and its negative (–) terminal to
terminal "5" and let the motor turn.
b. Disconnect terminal "1" from battery positive
(+) terminal, and let the motor stop.
c. Connect terminals "1" and "3" with a jumper
wire, and connect terminal "4" to battery
positive (+) terminal.
Observe the motor turns once again then
stops at a specified position as shown.
5
I4RS0A940010-
5
I4RS0A940011-
6
6
2
1
4
2. Windshield wiper arms with wiper blades
6. Ceramic line
7. Wiper blade center
d. Repeat Step 1) to 3) several times and check
that the motor stops at the specified position
every time.
If check result is not satisfied, replace motor.
Rear Wiper (If Equipped) Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove arm cover (1), rear wiper arm nut (2), rear
wiper arm with blade assembly (3), rear wiper pivot
cap (4), rear wiper nut (5) and rear wiper seal (6).
1
2
3
4
3) Remove rear end door trim referring to "Rear End
Door Lock Assembly Removal and Installation: in
Section 9F".
4) Disconnect coupler from rear wiper motor.
5) Remove rear wiper motor.
7
2
3
5
I4RS0A940012-
S4RS0A9406013
5
6
I4RS0A940013-
Advertisement
