Advertisement
Tightening torque
Manual detent spring bolt (a): 10 N·m (1.0 kg-m,
7.5 lb-ft)
3) Install parking lock pawl rod (2) to manual valve lever
(1).
4) After applying A/T fluid to new manual valve lever
(1), install new manual shift shaft (4), new spacer (3)
and manual valve lever to transaxle case.
5) After installing manual valve lever pin (2) by using
spring pin remover with 3 mm (0.12 in.) in diameter
(5) and hammer, turn spacer to set the position as
shown in figure. Then caulk spacer with a punch.
6) Install parking lock pawl bracket (1) to transaxle
case.
Tightening torque
Parking lock pawl bracket bolt (a): 7.5 N·m (0.75
kg-m, 5.5 lb-ft)
I2RH0B510259-
7) After applying A/T fluid to new O-rings, install them
to 1st and reverse brake piston (3).
I2RH0B510260-
1. Inner O-ring
8) Install 1st and reverse brake piston (1) to transaxle
case (2).
NOTE:
Be careful not to damage O-ring when
installing 1st and reverse brake piston.
I2RH0B510261-
Automatic Transmission:
2. Outer O-ring
5A-151
I2RH0B510262-
I2RH0B510263-
I2RH0B510264-
Advertisement
