Advertisement
Headlight Bulb Replacement
WARNING:
• To avoid danger of being burned, don't
touch when the bulb is hot.
• Don't touch glass surface of bulb, to avoid
deteriorate as the case may be unclear
when bulb light on at dirty condition.
1) Disconnect negative (–) cable at battery.
2) Disconnect coupler from bulb.
3) Remove socket cover (1).
4) Replace bulb (2) and assemble all removed parts.
Headlight Aiming Adjustment with Screen
NOTE:
• Unless otherwise obligated by local regulations, adjust headlight aiming according to the following
procedure.
• After replacing headlight housing, be sure to adjust aiming.
1) Make sure the following items.
• Place vehicle on a flat surface in front of blank wall (screen) (1) ahead of headlight surface.
Distance "a"
10 m (32.8 ft.)
• Adjust air pressure of all tires to the specified value respectively.
• Bounce vehicle body up and down by hand to stabilize suspension.
• Carry out aiming with a driver aboard.
Driver's weight
75 kg (165 lb)
2) Check to see if hot spot (high intensity zone) of each low beam axis falls as shown in figure.
Hot spot specification
Angle "b": 0.75 (Specification)
Calculated distance "H": Approx. 130 mm (5.15 in.)
S4RS0A9206002
Lighting Systems:
2
iii)
ii)
9B-6
1
i)
I4RS0A920005-
S4RS0A9206003
Advertisement
