Lanserver Ex3 Is Whistling - Avid Technology Unity LANserver EX3 Setup Manual

LANserver EX3 Is Whistling

n
Checking That the Operating System Is Properly
Installed
n
Problem: The LANserver EX3 is making a whistling sound.
Possible Cause: One of the power supply modules might have failed. Perform
the following checks:
• Make sure all the power supply modules are plugged in.
• Make sure each power supply module has a green LED lit.
• Make sure the power supply module switch is turned on.
• Make sure both power cords are plugged into an active electrical circuit.
• Make sure one of the electrical circuits has not overloaded and tripped the
circuit breaker. If the power cords are plugged into different circuits,
check both circuits for a tripped circuit breaker.
• Press the red button near the top center on the back of the LANserver EX3
The whistling should stop.
The LANserver EX3 can continue to run if one of the power supply modules is
turned off or fails, or if one of the power cords is not plugged in.
• Contact Avid Customer Support for further assistance and possible power
supply module replacement.
The LANserver EX3 runs the Windows 2000 Server operating system with
Service Pack 4. Avid ships each LANserver EX3 with the Windows 2000
Server, Service Pack 4. If you are concerned that the operating system might
not be appropriately installed, you can check it by following the procedure in
this section.
See the Avid Unity MediaNetwork Release Notes for a list of appropriate
hotfixes.
LANserver EX3 Is Whistling
71