Starting The Descaling Process - Miele H6260BP Operating And Installation Instructions

Starting the descaling process

As soon as the intake process  
has been started, the descaling
process can no longer be cancelled.
 Select the Moisture Plus  function.
 Use the rotary selector   to select
.
 Confirm with OK.
If Moisture Plus  has already been
locked, the descaling process can be
started immediately by touching OK.
The prompt for the drawing in process
( ) will appear and the triangle  will
flash under .



 Confirm with OK.
The intake process will begin. You can
hear the pump while this is happening.
The amount of solution specified can be
more than the amount which is actually
taken in. Some of the solution may
therefore be left in the container at the
end of descaling.
The Activation phase ( ) will begin.
You can follow the duration as it counts
down.
 Leave the container with the tube
The system will take in more liquid at
approximately 5 minute intervals. You
will hear the noise of the pump for a

moment or so.
The descaling step can be displayed:
 Select .
 Use the rotary selector   to move
 To display the time remaining, use the
At the end of the activation phase a
buzzer will sound, if the buzzer is
switched on (see "Settings -  ").
Cleaning and care
  

connected to the water intake pipe in
the oven. Top the container up with
approx. 300 ml of water, as the
system will need to draw in some
more liquid during the activation
phase.
the triangle  until it appears
under .


rotary selector   to move the
triangle  until it is under .

h


 

109