Henny Penny PXE-100 Operator's Manual page 66

4-4.
FILTER CONTROL
(CONT.)
March 2014
FC-42 "COOK MODE TIMED AUTO-MIX, IF BAD
BOTTOM PROBE"
This option is used only if the temperature probe on the bottom
of the pot has failed or is disconnected.
1.
Enter a new value by using the product numbers.
2.
Press the button next to √ to accept the new value.
3.
Press the button next to X to return to default or previous
setting.
Dispose Settings
FC-43 "DISPOSE: DROP OIL: DRAIN OPENING"
This setting specifies the drain opening to be used when draining
the oil to a disposal cart, shuttle, or bucket for disposal. (Does
not apply to Bulk Dispose operations.)
1.
Enter a new value by using the product numbers.
2.
Press the button next to √ to accept the new value.
3.
Press the button next to X to return to default or previous
setting.
Miscellaneous Settings
FC-44 "ALWAYS ASK 'IS POT FILLED?' "
This option can be engaged to always ask -- at the end of each
Quick Filter, Auto-Mix, and Polish operation -- if the pot is
filled. Normally, the control asks "Is Pot Filled?" only if it
has pumped for a long time attempting to fill the pot, but no
temperature rise was observed on the upper temperature probe.
1.
Press the + or - to select either "YES" or "NO".
FC-45 "ANY FILL: NOT FILLED, EXTRA PUMP
TIME"
When refilling the pot at the end of a Quick Filter, Auto-Mix,
or Polish operation, the control closes the drain and runs the
pump until a suitable temperature rise is observed on the upper
temperature probe (the level probe). If no temperature rise is
seen after pumping for a reasonable maximum pumping time,
the control stops, turns the pump off, and asks "Is Pot Filled?".
1.
Enter a new value by using the product numbers.
2.
Press the button next to √ to accept the new value.
3.
Press the button next to X to return to default or previous
setting.
58