Henny Penny PXE-100 Operator's Manual page 57

4-4.
FILTER CONTROL
(CONT.)
March 2014
FC-10 "DAILY FILTER + POLISH: FILL: DETECT
AT LEVEL PROBE, KEEP PUMPING"
When refilling the pot, specifies how long to keep pumping after
the oil reaches the upper probe and the expected temperature rise
is observed.
1.
Enter a new value by using the product numbers.
2.
Press the button next to √ to accept the new value.
3.
Press the button next to X to return to default or previous
setting.
In a Daily Filter, a Fill operation can be stopped by the user at
any time.
FC-11 "DAILY FILTER: FILL: NO DETECT: MAX
PUMP"
If the fryer pumps for this amount of time during the Fill phase
without observing a temperature rise on the upper temperature
probe, the control turns the pump off, and asks "IS POT
FILLED?". If pot is not filled completely, press "NO" and the
pump will attempt to fill further.
1.
Enter a new value by using the product numbers.
2.
Press the button next to √ to accept the new value.
3.
Press the button next to X to return to default or previous
setting.
For 50 Hz systems, or if the control routinely gives up before the
pot is refilled, you might need to increase the "max pump" time
from the default value. 50 Hz pumps run more slowly than 60 Hz
pumps.
49