Henny Penny PXE-100 Operator's Manual page 45

3-23.
PREVENTIVE
MAINTENANCE
(CONT.)
Dec. 2013
Cleaning DeadWeight-Monthly
DO NOT REMOVE DEADWEIGHT ASSEMBLY
WHILE FRYER IS OPERATING OR SEVERE
BURNS OR OTHER INJURIES WILL RESULT.
Allow the steam stack enough time to cool before
proceeding with the following steps.
1.
Loosen the 3 thumb screws that secure the steam stack to the top of
the fryer. Do NOT fully remove the screws from the steam stack.
2.
Pull the steam stack out of the fryer revealing the deadweight.
3.
Use a towel to wipe any build up from the dead-weight.
4.
Place the gasket onto the factory location, aligning the 3 screw
holes.
5.
Place the steam stack back into place and tighten the 3 thumb
screws.
37