Switching On The Unit; Practical Use - Dentsply Sirona inFire HTC speed Operating Instructions Manual

Dentsply Sirona
Operating Instructions inFire HTC speed
Column Designation
Heating rate (heating and
cooling down speed)
Holding temperature
Holding time
Switch-on
Status display
Explanation
61 30 459 D 3497
D 3497.201.01.19.02 09.2017
Description of the columns on the left side with the freely programmed
furnace programs
Description
The heating and cooling down speed of the corresponding level is
set up / displayed in this column. The heating and cooling down
speed can range from 1 °C / min (33.8 °F / min) to 99 °C / min (210
°F / min).
The temperature of the corresponding level is set / displayed in this
column.
The holding time of the corresponding step is set / displayed in this
column.
The laboratory furnace heats up and cools down in up to four temperature
steps. It is possible to heat or cool down within the program run.
6.2

Switching on the unit

✔
The unit has been properly set up and connected to a power outlet.
➢ Turn on the main switch.
 The main switch is illuminated and the LCD screen shows a status
display for 3 seconds before the standby display is shown.
The furnace door opens automatically after a cooled furnace has been
switched on.
Line 1 (S4)
Line 2 (S3)
Line 3 (S2)
Line 4 (S1)
6.3

Practical use

The furnace can be used immediately after entering the required
program.
NOTICE
Risk of breakage
The sintering trays to be used are fragile. They break with strong
temperature fluctuations and under mechanical stress.
Model number (model no.:)
Order number (REF:)
Serial number of electronics (serial no.:)
Hardware version (HW:) and software version (SW:)
6 Operation
6.2 Switching on the unit
19