Switching The Unit On And Off - Dentsply Sirona Primeprint Instructions For Use Manual

5 Commissioning
5.3 Putting the unit into operation
42
5.3.5

Switching the unit ON and OFF

NOTE
Do not put the unit into operation at low temperatures!
If you move the unit to the operating site from a cold environment,
condensation may form and result in a short circuit.
Within the machine, grease depots are included for lubricating
components that can cause error messages at low temperatures.
ü Install the unit at room temperature.
➢ Wait until the unit has reached room temperature and is
absolutely dry (for at least one hour)
Ä The unit is dry and can be put into operation.
NOTE
Do not adjust the line voltage
The unit automatically adjusts to the line voltage.
Switching on the unit
ü The unit is connected to the power supply.
1. The main switch on the left rear side of the unit is set to position I
(ON).
2. Press the ON/OFF button on the front panel.
Ä The unit switches on.
Switching off the unit
ü The unit has finished the machining operation.
➢ Briefly press the ON/OFF button on the front panel.
Ä When you let go of the button, the unit switches off.
Dentsply Sirona
Instructions for Use Primeprint
67 45 1 73 D3691
D3691.201.01.01.02 04.2021