Programs; Plan For Assigning Furnace Programs - Dentsply Sirona inFire HTC speed Operating Instructions Manual

6 Operation
6.6 Programs
Explanation
38
5. Ensure that the door guide pin is locked in place in the locating hole
(A) provided for this purpose when inserting the furnace door for
oxide ceramics.
6. Push the furnace door for oxide ceramics until the end stop in the
furnace fastening clamp. Unlock the guide pin once more by pulling it
and turning it counter-clockwise. Now pull the door forward carefully
until the guide pin locks in place in the corresponding locating hole in
the furnace fastening clamp.
NOTICE
Sinter program does not start
If the guide pin does not lock in place correctly in the slot of the furnace
fastening clamp, then the door will not close properly once a sintering
program is started. The sintering program will not start.
6.6

Programs

With the inFire HTC speed sintering furnace, sintering is controlled via
callable programs [ → 39].
● inFire HTC speed has fixed programs for sintering certain dental
oxide ceramics.
● There are freely programmable programs for other dental oxide
ceramics.
● The inFire HTC speed with integrated or retrofitted gas management
system contains additional programs for the sintering of non-precious
metals. This sintering process is conducted in a protective gas
atmosphere with argon-flooding of the sintering bells that have been
developed especially for this purpose (see section "Non-precious
metal (NPM) sintering (optional) [ → 30]").
6.6.1

Plan for assigning furnace programs

The furnace control system contains 30 program channels:
● Programs 1 – 19 are fixed and cannot be seen by the user, i.e.
heating rates, holding temperature, and holding time are not
displayed and can only be changed by means of a software update
from the manufacturer.
● Programs 20 – 26 (7 program channels) can be freely defined by the
user.
● Programs 27 – 28 (2 program channels) can be freely defined and
can also be assigned the special "pre-drying" function on the first
program level (S1).
● Programs 29 – 30 (2 program channels) can be freely defined and
can also be assigned the special "ventilation" function.
Dentsply Sirona
Operating Instructions inFire HTC speed
61 30 459 D 3497
D 3497.201.01.19.02 09.2017