Dentsply Sirona - Dentsply Sirona inFire HTC speed Operating Instructions Manual

Dentsply Sirona

Operating Instructions inFire HTC speed
61 30 459 D 3497
D 3497.201.01.19.02 09.2017
CAUTION
Risk due to incorrect setup
The inFire HTC speed high-temperature furnace may only be set up in
dry rooms and must never be in contact with any liquids. Furniture items
and other equipment in the vicinity of the furnace must not contain any
explosive, flammable or easily ignitable materials. It is prohibited to keep
or store ignitable or flammable gases or liquids in the room where the
furnace is set up.
CAUTION
Damage resulting from unauthorized alterations
The inFire HTC speed high-temperature furnace may only be altered
with our express prior approval. We are not liable for unauthorized
alterations of any kind.
➢ Switch the unit off and disconnect the power plug prior to performing
maintenance tasks.
WARNING
Separate circuit
The inFire HTC speed high-temperature furnace must always be
connected to a separate circuit with at least a 16A fuse. The fuses must
be of the C type.
WARNING
Risk of burns due to objects falling out
As there is a serious risk of burns in this case, it is essential to install a
fire-proof table and floor covering.
I. For safety reasons, the furnace must be operated when standing. Only
in this way is it possible for the user to quickly avoid parts that fall out.
II. When using super speed sintering, wearing heat-resistant protective
clothing is recommended. In accordance with professional association
regulations, the operator of the site is responsible for providing the user
with appropriate protective clothing.
III. The operator of the site is responsible for giving the user appropriate
safety instructions.
IV. If a fracture occurs during the sintering process as a result of a failure
to adhere to the recommended drying procedure, there is a risk that hot
objects will fall out as soon as the furnace door is opened.
V. The furnace should only be loaded and unloaded using the crucible
fork. For safety reasons, a trained user must be present when the
furnace is being loaded or unloaded.
3 Safety information
9