Entering The Program Values For Fast Sintering; Programming Example For Fast Sintering (Speed Sintering); Dentsply Sirona - Dentsply Sirona inFire HTC speed Operating Instructions Manual

6 Operation
6.6 Programs
42
3. Press the S2 key (=YES) to confirm the loading procedure.
Programming step S3
1. Press the S3 key. The cursor will blink in the "Heating velocity"
column of line S3.
2. Enter the value 12. The cursor will blink in the "Temperature" column.
3. Enter the value 1540. The cursor will blink in the "Holding time"
column.
4. Enter the value 120.
Programming step S4
➢ Enter the values for step 4 as shown in the table.
NOTICE
Entries with less than four digits
If you did not enter the temperature as 0300 and used 300 instead, the
cursor must be manually moved to the "Holding time" column by
pressing the S1 key.
Steps S1 and S2
Since steps S1 and S2 are not needed in this example, you can leave
their values at 0 with the exception of the heating velocity.
Storing the program
1. Press the Memory key.
2. Press the S2 key (=YES).
 The program is now stored under the number 01.
6.6.6.2 Entering the program values for fast sintering (speed sintering)
For a fast or speed sintering program with S3, the cooling speed must be
set to > 30 °C (86 °F/min); cooling is then performed via the door opening.

Programming example for fast sintering (speed sintering)

6.6.6.3
Heating speed
(°C/min)
S4 70
S3 70
S2 70
S1 12

Dentsply Sirona

Operating Instructions inFire HTC speed
Temperature Holding time
(°C) (min)
750 0
1100 0
1540 30
0 0
61 30 459 D 3497
D 3497.201.01.19.02 09.2017