Dentsply Sirona - Dentsply Sirona inFire HTC speed Operating Instructions Manual

Dentsply Sirona

Operating Instructions inFire HTC speed
61 30 459 D 3497
D 3497.201.01.19.02 09.2017
Using a second sintering tray
If you wish to stack, you require a stacking disc that is not split.
✔
The first sintering tray is constructed as described above.
NOTICE
Risk of damage to the furnace chamber
If incorrectly positioned, the sintering tray collides with the furnace
chamber insulation.
➢ Ensure that the stacking disc and sintering tray are positioned
centrally, before closing the furnace or starting the process.
1. Position the stacking disc centrally on the first sintering tray.
2. Position the second sintering tray centrally on the stacking disc and
start the sintering process.
Removing the sintering tray with the crucible fork
The furnace should only be loaded and unloaded using the supplied
crucible fork. Removal is via the guide grooves in the upper door
insulation brick.
1. After sintering, slide the crucible fork to the end of the guide slots.
2. Lift the sintering tray with the split support disk and place it on a
fireproof tray to cool down, e.g. on the crucible tray.
6 Operation
6.3 Practical use
25