Certification; Intended Use - Dentsply Sirona inFire HTC speed Operating Instructions Manual

4 Technical description
4.2 Certification
12
4.2

Certification

CE mark
This product bears the CE mark in accordance with the provisions of
Council Directive 2006/42/EC (machinery directive).
CAUTION
CE mark for connected products
Further products which are connected to this unit must also bear the CE
mark. These products must be tested according to the applicable
standards.
We declare conformity for the inFire HTC speed ceramic sintering furnace
on the basis of the following standards:
● Safety: IEC 61010-1:2001 2nd edition and IEC 61010-2-010:2003
2nd edition
● EMC: EN 61326:2006
● Risk assessment and risk reduction EN ISO 12100:2010
EAC certification
Mark of conformity of the Eurasian Economic Community
RoHS compliance
This symbol indicates that this product does not contain any toxic or
hazardous substances or components above the maximum
concentration value set out in the Chinese standard SJ / T 11364-2014,
and can be recycled following disposal and should not be carelessly
discarded.
4.3

Intended use

The inFire HTC speed high-temperature furnace is exclusively intended
for sintering oxide ceramics for use in dental technology at up to 1,650 °C
(3,002 °F).
In addition to the sintering of oxide ceramics, with an integrated or
retrofitted gas management system the sintering of pre-sintered non-
precious metals is also possible.
Dentsply Sirona
Operating Instructions inFire HTC speed
61 30 459 D 3497
D 3497.201.01.19.02 09.2017