Mc68Ec020 Bus Arbitration - Motorola MC68020 User Manual

5.7.2 MC68EC020 Bus Arbitration

The sequence of the MC68EC020 bus arbitration protocol is as follows:
1. An external device asserts the BR signal.
2. The processor asserts the BG signal to indicate that the bus will become available at
the end of the current bus cycle.
3. The external device asserts the BR signal throughout its bus mastership.
BR may be issued any time during a bus cycle or between cycles. BG is asserted in
response to B R; it is usually asserted as soon as BR has been synchronized and
recognized, except when the MC68020 has made an internal decision to execute a bus
cycle. Then, the assertion of BG is deferred until the bus cycle has begun. Additionally, BG
is not asserted until the end of a read-modify-write operation (when RMC is negated) in
response to a BR signal. When the requesting device receives BG and more than one
external device can be bus master, the requesting device should begin whatever
arbitration is required. The external device continues to assert BR when it assumes bus
mastership, and maintains BR during the entire bus cycle (or cycles) for which it is bus
master. The following conditions must be met for an external device to assume mastership
of the bus through the normal bus arbitration procedure:
• The external device must have received BG through the arbitration process.
• AS must be negated, indicating that no bus cycle is in progress, and the external
device must ensure that all appropriate processor signals have been placed in the
high-impedance state (by observing specification #7 in Section 10 Electrical
Specifications).
• The termination signal (DSACK1/DSACK0) for the most recent cycle must have been
negated, indicating that external devices are off the bus.
• No other bus master has claimed ownership of the bus.
Figure 5-46 is a flowchart of MC68EC020 bus arbitration for a single device. Figure 5-47 is
a timing diagram for the same operation. This technique allows processing of bus
requests during data transfer cycles.
Bus arbitration requests are recognized during normal processing, RESET assertion,
HALT assertion, and when the processor has halted due to a double bus fault.
5-70 M68020 USER'S MANUAL MOTOROLA