Problems At Power Up; What To Do If Things Go Wrong - DEC 600 Installation And Service Manual

Figure A–2 shows all of the codes that are displayed on the system operation
display. If the displayed codes indicate that the system is loaded, or waiting
to load, refer to Section 4.8 for details of what to do next. If the displayed
codes indicate that there is a problem, refer to Section 9.2 for problem solving
procedures.

4.7 What to Do if Things Go Wrong

Check Table 4–2 for LED state shown and take the corresponding action.
Table 4–2 Problems at Power Up
Symptom
Processor card FAULT LED lit
Memory card FAULT LED
No LEDs lit on Network
Interface Card
Network Interface Card FAULT
LED
Network Interface Card FAULT
and READY LEDs lit
Network Interface Card READY
LED continuously flashing
4.8 What to Do Next
When the system displays show that the DECNIS 600 is running successfully:
1. Complete the DEC Network Integration Server 600 Configuration card and
the Network Interface Card configuration cards.
2. If the software is not installed, follow the procedures on the DEC Network
Integration Server Installation card to install the software.
Action
Follow the procedures in Section 10.6.
Follow the procedures in Section 10.7.
Card is not enabled, may be faulty or have faulty
connections. Refer to Section 3.9 to enable card. If
problem persists, go to Section 10.10.
A diagnostic error was found on the Network
Interface Card. Go to Section 10.9.
Network Interface Card is in the ATTENTION
state. A diagnostic error was found on the card or
cables associated with it. Go to Section 10.9.
Network Interface Card not configured. Refer to
the software documentation for details of how to
configure the card.
Testing the Installed System 4–11