Table of Contents
Advertisement
Notes
A. Set the power switch to 0 (OFF):
Power switch
set to 0 (OFF)
B. The problem may be caused by a faulty power module. Follow the
procedures in Section 11.1 to remove the power module and install a
new one.
C. Monitor the displays and LEDs on the DECNIS 600 (see Section 9.2)
and, if the software is loaded, monitor event messages logged by the
system. If there is still an overtemperature problem, the system logs
overtemperature warning messages before shutting down. Refer to the
software documentation for more information.
Locating the Faulty Component 10–15
LKG-5683-91I
Advertisement
Table of Contents
