Tasks - DEC 600 Installation And Service Manual

5.1 Tasks

Follow the procedures in Sections 5.2 to 5.9 to:
1. Prepare to install the Network Interface Card
2. Attach the static protection equipment
3. Remove the slot cover that covers the system slot
4. Install the card in the system
5. Install the distribution panel (if supplied)
6. Attach the communications cables
7. Enable the Network Interface Card
8. Monitor the Network Interface Card LEDs
5.2 Preparation
Before you begin the installation procedure, check the contents of the Network
Interface Card kit. The Cabling Instructions and Specifications card for the
Network Interface Card lists the contents of the kit.
Do not remove the Network Interface Card from its antistatic
packaging until you have completed the procedures in Section 3.4.
The packaging protects the card from damage caused by static
discharge.
When you unpack the kit, keep all of the packaging in case you need to remove
and replace the Network Interface Card.
If any part of the kit is missing or damaged, contact your local Digital
representative.
Before you start, do not power down the system.
5–2 Adding Network Interface Cards to a Running System
Note