Notes
A. There could be a problem on the Network Interface Card used for loading
the DECNIS 600. Check the LEDs on each Network Interface Card (see
Section 9.2.3).
B. Complete the following:
1. Set the power switch to 0 (OFF).
2. Hold in the dump button (D1) on the processor card. Appendix D shows
the location of the dump button.
3. Set the power switch to 1 (ON) and continue to hold the dump button
in for a further 5 seconds (approximately).
4. Release the dump button.
5. Refer to Section 9.2 to monitor the DECNIS 600 displays.
Locating the Faulty Component 10–85