9.2.3 Monitor Network Interface Card LEDs
There are three LEDs on each Network Interface Card:
HOTSWAP LED
(Yellow)
FAULT LED
(Yellow)
READY LED
(Green)
As the DECNIS 600 runs its diagnostic tests and loads the software, the
Network Interface Card LEDs flash and flicker. When testing is complete and
the processor card shows that the software is loaded and running, the READY
LED on each Network Interface Card should be lit constantly.
If the READY LED on a Network Interface Card is not lit, refer to Table 9–3
to check the state of the Network Interface Card and take the action shown in
the corresponding column.
9–8 Identifying the Problem
LKG–5659-91I