Selecting Stormscope Mode; Editing/Creating A Flight Plan Manually - Honeywell KMD-150 Pilot's Manual

Getting Started

SELECTING STORMSCOPE MODE

If a Stormscope
installed the display
screen can be selected
from the MAIN MENU.
When lightning
detected, the KMD150
will annunciate LIGHT-
NING in the MAP mode,
to see details of the strike
select MAIN MENU and
STORM SCOPE to call
the strike screen ranged
at 200nm. From this
entry screen a number of
options all identified on the screen (e.g. ZOOM IN, ZOOM OUT, MODE
Strike or Cell) can be selected. To clear and refresh the display press
CLEAR and to return to the main navigation screen, press MAP.

EDITING/CREATING A FLIGHT PLAN MANUALLY

From MAIN MENU select
the FLIGHT PLAN key,
followed by EDIT FPLN.
Use the joystick to select
the desired flight plan
number and then press
SELECT. To insert an
item press INSERT ITEM
and follow the Database
Selection
explained earlier in this
section of the manual.
To remove an item from
the flight plan move the cursor over the item using the joystick and press
DELETE ITEM. A flight plan can be systematically built using the
INSERT ITEM key. The flight plan can be inverted by pressing the
INVERT FPLN key. If you wish to fly the flight plan, ensure that the flight
plan arrow (shown on the side of the flight plan list) is highlighting the leg
you wish to fly, the press FLY FPLN. Alternatively use the PREV PAGE
key to return to MAIN MENU. This function is not available in External
GPS Mode.
Rev 1 Mar/2000
is
is
process
24
KMD 150 Pilot's Guide