Title And Help Screens; Screen 1: Title Screen - Honeywell KMD-150 Pilot's Manual

TITLE AND HELP SCREENS

To switch the unit on, push the On/Off/Brightness control in then rotate
fully clockwise.
Your unit produces a variety of tones and alarms to assist you in correct
operation. At this stage only two types of tone need concern you. These
are:
1 short beep sounds when you press a valid key.
2 short beeps sound when you press a key that is not assigned.
The Title Screen appears
each time the unit is
switched on. A database
confirmation screen will
then be displayed which
you are required to
acknowledge by pressing
Key 1, which will be
labeled OK. When you
have acknowledged the
validity of the database,
the Title Screen will be
redisplayed as shown
here.
Key 1 calls Screen 2,
Key 2 calls Screen 7,
Key 3 calls Screen 20,
being switched on, the unit has received valid fix information from the
internal GPS receiver, Key 3 DEMO MODE will for safety reasons
default to NOTE PAD and call
set up to receive external GPS/LORAN data. This is the only Screen on
which Demo Mode can be activated.
Key 4 calls Screen 21,
Key 5 calls Screen 38,
To switch the unit off, pull the On/Off/Brightness control.
Do not try to force the control knob past its end stops.
Rev 1 Mar/2000

Screen 1: Title Screen

which is the Main Menu Screen.
which is the Flight Planning Mode Cover Screen.
which is the Demo Mode Setup Screen. (If, since
screen 62.
which is the Setup Cover Screen.
which is the Map Mode Screen.
WARNING:
33
Title and Help Screens
This also applies if the unit is
KMD 150 Pilot's Guide