Nav Mode Setup; Screen 23: Nav Mode Customization Screen - Honeywell KMD-150 Pilot's Manual

Setup Screens

NAV MODE SETUP

This screen is not avail-
able in External GPS
mode. When you first
enter this Screen the cur-
rent settings are dis-
played with a cursor over
the words CDI SCALE.
You then have to use the
joystick to move the
cursor up or down. Once
the cursor is over the
Screen 23: NAV Mode Customization
heading you wish to alter,
Screen
moving the joystick to the
right will move the cursor over to the set of options available for that
heading.
The various settings available for each heading are listed below. The
default settings are those shown in the previous illustration. To reset the
values on this screen to their defaults, press Key 3 RESET VALUES.
This will reset the values on the displayed screen only. In order to reset
all user defined data globally, see the Clear Memory screens later in this
section.
CDI SCALE: 0.3 / 1.0 /2.5 /5.0nm.
CDI DISPLAY: bar / numeric / off
CDI ALARM: on / off.
WPT ALERT: 1 / 2 / 3 / 4 / 5 / 6 / 7 / 8 / 9 / 10 / 11 / 12 / 13 / 14 / 15 / 16 /
17 / 18 / 19 / 20 nm
AUTO LEG SELECT: on / off.
AUTO NEXT LEG: on / off.
TURN ANTICIPATION: on / off
FLIGHT PLAN DISPLAY: active leg / all legs.
INTERNAL ALARM: on / off.
EXTERNAL ALARM: on / off.
CDI SCALE: This enables you to choose which of the given distances
you want the unit to use as the setting for the full-scale deflection of the
Course Deviation Indicator (CDI) in NAV mode. This value is always in
nautical miles.
CDI DISPLAY: This allows you to set the CDI display in Map Mode to
show either a bar-graph, or a numeric read-out of course deviation or to
92
Rev 1 Mar/2000
KMD 150 Pilot's Guide