Table of Contents
Advertisement
SELECTING IDENTIFIERS
USING THE DATA/SCAN
KNOB
Scanning Flightplan
Waypoints
If FPLN WPT is selected in
the AREA field (as shown in
Figure 38), the SCAN Knob
can be used to sequence
through all the waypoints on
the active flightplan. The next
waypoint from the current
position will be displayed.
Turn the inner knob clock-
wise to sequence forward
through the waypoints. Turn
the inner counter-clockwise
to
sequence
through the waypoints.
Finding User Defined
Areas by Identifier
If USER DEFINED has been
selected, as in Figure 39, use
the Control Knob to enter
data (note cursor position in
Figure 39) or scan through
available location options.
The following is an example
of using this feature.
1. The cursor will be over the
first character of the waypoint
identifier. Select the desired
character by turning the inner
knob.
The screen will
change to that shown in
Figure 40.
Revision 2 Nov/2002
backward
Figure 38
Figure 39
Figure 40
35
KMD 550/850 FIS Addendum
Normal Operation
Advertisement
Table of Contents
