Routing Table Commands - D-Link DES-3010F Command Line Interface Manual

The routing table commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create iproute
delete iproute
show iproute
Each command is listed, in detail, in the following sections.
create iproute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table:
DES-3026:4#create iproute default 10.48.74.121 1
Command: create iproute default 10.48.74.121 1
Success.
DES-3026:4#
delete iproute default
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the default IP route 10.53.13.254:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
[default] <ipaddr> {<metric 1-65535>}
[default]
{<network address>} {static}
Used to create IP route entries to the Switch's IP routing table.
create iproute [default] <ipaddr> {<metric 1-65535>}
This command is used to create a default static IP route entry to the
Switch's IP routing table.
<ipaddr> − The gateway IP address for the next hop router.
<metric 1-65535> − Allows the entry of a routing protocol metric entry
representing the number of routers between the Switch and the IP
address above. The default setting is 1.
Only administrator-level users can issue this command.
Used to delete a default IP route entry from the Switch's IP routing
table.
delete iproute [default]
This command will delete an existing default entry from the Switch's
IP routing table.
None.
Only administrator-level users can issue this command.
R
OUTING
166
27
T C
ABLE OMMANDS