Symmetricom SSU-2000 User Manual page 285

Table 9-3. SSU-2000 System Components (Continued)
Item Description
28. RS-422 Output Module
29. Japan Composite Clock
Output Module
30. Japan Sine Wave
Output Module
31. DS1 Line Re-Timing
Module
12713020-002-2 Revision F.01 – January 2007
Part Number
23413287-000-0 1. Minimum of one Output module of any
2. Each Output module provides 10
3. Outputs can be from 8 to 4096 kHz.
4. Each Output module or redundant pair
5. Each two redundant Output modules
23413306-000-0 1. Minimum of one Output module of any
2. Each Output module generates 20
3. Each output module or redundant pair
4. Each two redundant Output modules
23413304-000-0 1. Minimum of one Output module of any
2. Each Output module provides 20
3. Each output module or redundant pair
4. Each two redundant Output modules
23413301-000-0 1. Minimum of one Output module of any
234-13301-001-0
2. The dual or quad LRU provides retiming
3. A corresponding Cut-Through Assembly
Chapter 9 Hardware Configuration Guide
SSU-2000 Configuration Chart
Notes
type required.
balanced square-wave outputs (TTIP
and TRING signal pairs) and 10
single-ended (Ring) square-wave
outputs.
requires one Output I/O adapter panel.
require one Output Summer connector
(part number 22013070-000-0).
type required.
non-summable pairs with independently
configurable phase delay.
requires one Output I/O adapter panel.
require one Output Summer connector
(part number 22013070-000-0).
type required.
outputs at either 1.544 or 6.312 MHz.
requires one Output I/O adapter panel.
require one Output Summer connector
(part number 22013070-000-0).
type required.
on two or four DS1 lines to a Network
Element.
is required.
SSU-2000 User's Guide 285