Status Led Indicators; Front Panel Of The Japanese Sine Wave Input Module - Symmetricom SSU-2000 User Manual

LOS Phase Considerations
Phase reading not valid when in episode
Zero phase reading when episode ends
If signal returns before the port goes into episode, normalize subsequent phase
measurements to show continuous phase numbers before and after LOS
Others
Phase reading valid
Measurement Problems
If the MTIE values for a selected clock exceed either of the MTIE masks, the Input
module takes appropriate action according to the severity level associated with the
MTIE alarms. Refer to the ALARM command described in the SSU-2000 Technical
Reference for more information on alarm settings.

Status LED Indicators

The Japanese Sine Wave Input module is equipped with eight status LEDs as
shown in Figure
Figure 7-10. Front Panel of the Japanese Sine Wave Input Module
12713020-002-2 Revision F.01 – January 2007
7-10. The LED status assignments are described in
Chapter 7 Input Module Reference Data
Japanese Sine Wave Input Module
Table 7-13.
SSU-2000 User's Guide 191