Mld Snooping Configuration Examples; Ipv6 Group Policy Configuration Example - HP 6125XLG Configuration Manual

Task
Remove the dynamic MLD snooping
forwarding entries for the specified
multicast groups.
Remove dynamic router ports.
Clear statistics for the MLD messages
learned by MLD snooping.

MLD snooping configuration examples

IPv6 group policy configuration example

Network requirements
As shown in
snooping.
To enable Host A and Host B to receive only the IPv6 multicast data addressed to the IPv6 multicast group
FF1E::101, configure MLD snooping on Switch A and enable the switch to drop unknown IPv6 multicast
data instead of flooding it in VLAN 100.
Figure 37 Network diagram
Source
XGE1/1/6
1::1/64
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to
shown.)
2. On Router A, enable IPv6 multicast routing, enable MLD on Ten-GigabitEthernet 1/1/5, and
enable IPv6 PIM-DM on each interface.
<RouterA> system-view
[RouterA] ipv6 multicast routing-enable
[RouterA] interface ten-gigabitethernet 1/1/5
Figure 37, Router A runs MLDv1 and serves as the MLD querier, and Switch A runs MLDv1
XGE1/1/5
1::2/64 2001::1/64
Router A
MLD querier
Command
reset mld-snooping group { ipv6-group-address
[ ipv6-source-address ] | all } [ vlan vlan-id ]
reset mld-snooping router-port { all | vlan vlan-id }
reset mld-snooping statistics
Receiver
Host A
XGE1/1/8
XGE1/1/5 XGE1/1/7
Switch A
XGE1/1/6
Host C
112
Receiver
Host B
VLAN 100
Figure 37. (Details not