Mld Snooping Configuration Examples; Ipv6 Group Policy And Simulated Joining Configuration Example - HP A5500 SI Switch Series Configuration Manual

MLD snooping configuration examples

IPv6 group policy and simulated joining configuration example

Network requirements
As shown in
•
1/0/2 and to Switch A through GigabitEthernet 1/0/1. Router A is the MLD querier on the subnet.
MLDv1 runs on Router A, MLDv1 snooping runs on Switch A, and Router A acts as the MLD querier
•
on the subnet.
Receivers, Host A and Host B, are attached to Switch A, and they can receive IPv6 multicast traffic
•
addressed to IPv6 multicast group FF1E::101 only.
IPv6 multicast data for group FF1E::101 can be forwarded through GigabitEthernet 1/0/3 and
•
GigabitEthernet 1/0/4 of Switch A even if Host A and Host B accidentally temporarily stop
receiving IPv6 multicast data.
Figure 66 Network diagram for IPv6 group policy simulated joining configuration
Source
GE1/0/2
1::2/64
1::1/64
Configuration procedure
Enable IPv6 forwarding and configure IPv6 addresses
1.
Enable IPv6 forwarding and configure an IPv6 address and prefix length for each interface according to
Figure 66 (details not shown).
Configure Router A
2.
# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLDv1 on
GigabitEthernet 1/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] mld enable
[RouterA-GigabitEthernet1/0/1] pim ipv6 dm
[RouterA-GigabitEthernet1/0/1] quit
Figure 66, Router A connects to the IPv6 multicast source through GigabitEthernet
GE1/0/1
GE1/0/1
2001::1/64
Router A Switch A
MLD querier
Receiver
Host A
Receiver
GE1/0/4
GE1/0/3
Host B
GE1/0/2
Host C
262