Configuring An Eigrp Stub Operation: Example; Configuring An Eigrp Pe-Ce Configuration With Prefix-Limits: Example - Cisco ASR 9000 Series Configuration Manual

Configuring an EIGRP Stub Operation: Example

Configuring an EIGRP Stub Operation: Example
The following example shows how to configure an EIGRP stub. Stub operation allows only connected, static,
and summary routes to be advertised to neighbors.
router eigrp 200

Configuring an EIGRP PE-CE Configuration with Prefix-Limits: Example

The following example shows how to configure EIGRP to operate as a PE-CE protocol on a PE router. The
configuration is under VRF CUSTOMER_1. A maximum prefix is typically configured to ensure that one
set of customer routes do not overwhelm the EIGRP process.
router eigrp 500
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
270
metric maximum-hops 20
router-id 10.10.9.4
route-policy GLOBAL_FILTER_POLICY in
log-neighbor-changes
log-neighbor-warnings
interface Loopback0
!
interface GigabitEthernet 0/2/0/0
passive-interface
!
interface GigabitEthernet 0/6/0/0
hello-interval 8
hold-time 30
summary-address 10.0.0.0 255.255.0.0
!
address-family ipv4
stub connected static summary
router-id 172.16.82.22
log-neighbor-changes
log-neighbor-warnings
redistribute connected route-policy CONN_POLICY
interface GigabitEthernet0/6/0/0
passive-interface
neighbor 10.0.0.31
!
interface GigabitEthernet0/6/0/1
passive-interface
neighbor 10.0.1.21
!
!
!
vrf CUSTOMER_1
address-family ipv4
timers nsf route-hold 300
router-id 172.16.6.11
maximum-prefix 450 70
default-metric 200000 10000 195 10 1500
log-neighbor-changes
log-neighbor-warnings
redistribute maximum-prefix 350 70
redistribute bgp 1.65500 route-policy SITE_1_POLICY
interface GigabitEthernet 0/4/0/5
neighbor 10.22.1.1
!
!
!
Implementing EIGRP
OL-30423-03