User Interface - Cisco RV260 series Administration Manual

Getting Started
To open this page, select Launch Setup Wizard in the navigation pane and follow the on-screen instructions
to proceed. Refer to your ISP for the information required to setup your Internet connection.
Launch Setup Wizard
Initial Router Setup
VPN Setup Wizard
Initial Configuration
Change Administrator
Password
Configure WAN Settings
Configure USB Settings
Configure LAN Settings
Quick Access
Upgrade Router
Firmware
Configure Remote
Management Access
Backup Device
Configuration
Device Status
System Summary
VPN Status
Port Statistics
Traffic Statistics
View System Log

User Interface

The user interface is designed to make it easy to set up and manage the device.
The header toolbar icons are described in the table below.
Link to the Initial Router Setup.
Link to the VPN Status Wizard.
Link to the User Accounts page where you can change the administrator
password and set up a guest account.
Link to the WAN Settings page where you can modify the WAN parameters.
Link to the Mobile Network page where you can modify the USB configurations.
Link to the VLAN Membership page where you can configure the VLAN.
Link to the File Management page where you can update the device firmware.
Link to the Firewall >Basic Settings page where you can enable the basic
features of the device.
Link to the Config Management page where you can manage the router's
configuration.
Link to the System Summary page that displays the IPv4 and IPv6 configuration,
and firewall status on the device.
Link to the VPN Status page that displays the status of the VPNs managed by
this device.
Link to the Port Traffic page which displays the device's port status and port
traffic.
Link to the TCP/IP Services page which displays the device's port listen status
and the established connection status.
Link to the View Logs page which displays the logs on the device.
User Interface
RV260x Administration Guide
7