Tektronix TG8000 User Manual page 460

SDI7 Dual Channel SD/HD/3G SDI Video Generator module
3–310
DOLBY-E METADATA Downmix Preferred. Use this menu item to set the preferred
downmix of the Dolby E signal. This parameter is used in consumer decoders that
have stereo outputs. This parameter is part of the extended BSI.
Use the left (◄) and right (►) arrow buttons to select LoRo, Not Indicated, or
LtRt. Press ENTER to confirm the selection.
DOLBY-E METADATA LtRt Center Mix Level. Use this menu item to set the LtRt
center mix level of the Dolby E signal. This parameter indicates what level
shift should be applied to the center channel before adding it to the left and
right channels when downmixing to an LtRt output. This parameter is part of
the extended BSI.
Use the left (◄) and right (►) arrow buttons to select –3.0 dB, –4.5 dB, –6.0 dB,
Infinite, +3.0 dB, +1.5 dB, 0.0 dB, or –1.5 dB. Press ENTER to confirm the
selection.
DOLBY-E METADATA LtRt Surround Mix Level. Use this menu item to set the LtRt
surround mix level of the Dolby E signal. This parameter indicates what level
shift should be applied to the surround channels before adding them to the left
and right channels when downmixing to an LtRt output. This parameter is part of
the extended BSI.
Use the left (◄) and right (►) arrow buttons to select –3.0 dB, –4.5 dB, –6.0 dB,
Infinite, +3.0 dB, +1.5 dB, 0.0 dB, or –1.5 dB. Press ENTER to confirm the
selection.
DOLBY-E METADATA LoRo Center Mix Level. Use this menu item to set the LoRo
center mix level of the Dolby E signal. This parameter indicates what level
shift should be applied to the center channel before adding it to the left and
right channels when downmixing to an LoRo output. This parameter is part of
the extended BSI.
Use the left (◄) and right (►) arrow buttons to select –3.0 dB, –4.5 dB, –6.0 dB,
Infinite, +3.0 dB, +1.5 dB, 0.0 dB, or –1.5 dB. Press ENTER to confirm the
selection.
DOLBY-E METADATA LoRo Surround Mix Level. Use this menu item to set the
LoRo surround mix level of the Dolby E signal. This parameter indicates what
level shift should be applied to the surround channels before adding them to the
left and right channels when downmixing to an LoRo output. This parameter is
part of the extended BSI.
Use the left (◄) and right (►) arrow buttons to select –3.0 dB, –4.5 dB, –6.0 dB,
Infinite, +3.0 dB, +1.5 dB, 0.0 dB, or –1.5 dB. Press ENTER to confirm the
selection.
TG8000 Multiformat Test Signal Generator User Manual