Tektronix TG8000 User Manual page 134

Operating basics
2–56
9. Verify the status of the USB drive:
a. Press the up (▲) or down (▼) arrow button to select TG8000 : UTILITY
: USB <status>.
b. Verify that the USB status is Mounted.
c. If the status is Not Mounted, press the ENTER button to mount the USB
drive.
10. Back up the user created files:
a. Press the up (▲) or down (▼) arrow button to select TG8000 : UTILITY
: BACKUP/RESTORE.
b. Press the left (◄) or right (►) arrow button to select Backup All User
Data to USB, and then press the ENTER button to start the backup
process.
c. A warning message is displayed asking you to verify the operation. Press
the ENTER button to proceed or press the BACK button to cancel the
operation.
d. During the first stage of the copy process, the display shows the names
of the files as they are copied. Depending on the size of the files being
copied, this may take a couple of minutes.
e. When all of the files have been copied, the message "Finishing copy..." is
displayed while the file system buffers are emptied. This message may
appear for a couple of minutes.
f. When the backup operation is complete, the message "Backup completed
successfully" or "Restore completed successfully" is displayed before
the menu display returns to normal.
NOTE.
If the USB drive fills up before the backup operation completes, an
error message is displayed. Press the ENTER or BACK button to clear the
error message. (See page 2-66, Memory requirements.)
11. After the backup operation is complete, press the up (▲) or down (▼) arrow
button to select TG8000 : UTILITY : FIRMWARE UPGRADE.
12. Press the left (◄) or right (►) arrow button to select USB Upgrade, and then
press the ENTER button to start the upgrade process.
TG8000 Multiformat Test Signal Generator User Manual