Table 3 Ccu Configuration; Table 4 Eum Configuration - WaveRider LMS4000 User Manual

Table 3 CCU Configuration

Basic CCU Settings
Before the system can pass traffic, input or
modify the following CCU parameters:
• CCU Ethernet IP address
• CCU radio IP address
• Gateway router IP address
• Radio frequency
For instructions on how to set these
parameters, read the following sections:
• Quick Startup
• IP Network Planning
• Radio Network Planning

Table 4 EUM Configuration

Basic EUM Settings
Before the system can is implemented, input
or modify the following EUM parameters:
• EUM Ethernet IP address
• Gateway (CCU Radio) IP address
• Radio frequency
For instructions on how to set these
parameters, read the following section:
• Configuring the EUM
Note: Since the EUM is a wireless bridge, it
passes data without having a unit or
gateway IP address assigned. However, to
support system management (SNMP, for
example) of an EUM, a unique IP address
must be assigned. The EUMs all ship with
the same default unit and gateway IP
addresses, so if these are not changed you
will experience network IP conflicts.
APCD-LM043-4.0
on page 5
on page 53
on page 59
on page 97
Advanced CCU Settings
Once the system is passing traffic, you can
start to configure and fine tune the following
CCU features and functions:
• Grade of Service
• DHCP relay
• Port filtering
• SNTP time clock
• SNMP communities
You can find a technical description of these
features in CCU–EUM Interface — Detailed
Technical Description on page 28. You can
find procedures for configuring these
features in Configuring the CCU
83.
Advanced EUM Settings
Once the system is passing traffic, you can
start to configure and fine tune the following
EUM features and functions:
• Port filtering
• SNMP communities
• Customer list
For instructions on how to set these
parameters, read the following section:
• Configuring the EUM
3 Detailed Description
on page
on page 97
23