Installing The Eum; Before You Start The Eum Installation - WaveRider LMS4000 User Manual

9

Installing the EUM

9.1

Before you Start the EUM Installation

Before you start the EUM installation, ensure the following points have been addressed:
• The EUM has been configured with at least the following settings:
•
•
•
•
• The CCU network is installed and verified.
• DHCP relay is enabled at the CCU, with network access to a valid DHCP server.
• The end-user PC is equipped with an Ethernet interface card, and is configured to
obtain its IP address remotely, using DHCP.
• The installer knows the direction from the EUM to the CCU (WISP radio site).
• The installer has read this chapter.
• The installer knows the EUM IP address.
• The WISP has authorized the EUM at the CCU (or no communications will be
possible).
Procedures are provided below for addressing situations where some of the above items
could not be taken care of prior to the EUM installation.
APCD-LM043-4.0
IP address
Subnet mask
Gateway IP address
Radio frequency
105