Figure 38 Connecting The Eum Components; Figure 39 Connect The Dc Power Cord To The Eum - WaveRider LMS4000 User Manual

When you have completed the above tasks, connect the EUM AC/DC adaptor to an AC power
bar or outlet.
To Connect the EUM Components
1. Finger-tighten the antenna cable onto the corresponding connector at the back of the
EUM (refer to Step 1 in
or over tighten.
2. Connect the AC/DC adaptor to the EUM. To do this, line up the guides in the DC
power cord connector with the notches in the power plug on the EUM and press the
connector firmly into place (refer to
APCD-LM043-4.0
Step 3
Step 2
AC Cable
DC Cable
Pow er Bar
AC/DC Adapter
Figure 38 Connecting the EUM Components
Figure 38). Do not use wrenches or pliers. Do not cross-thread
WARNING!
You must connect the antenna to the modem before
operating the system. Failure to do so may result in
permanent equipment damage.
Press firmly at the base of
the DC connector
Figure 39 Connect the DC Power Cord to the EUM
Bracket
Antenna
Step 1
Antenna Cable
2
1
EUM
Denotes reserved ports. Do NOT Connect.
Figure 39).
9 Installing the EUM
Antenna
Connector
Ethernet
Connector
DC Power
Connector
109