2
Quick Startup
This section outlines the procedure for setting up a very simple LMS4000 900 MHz radio
network consisting of one CCU and one EUM. This simple network, which can be set up in a
lab environment, helps you become familiar with basic LMS4000 configuration and operation.
As you become more confident and are ready to progress to customer installations,
WaveRider recommends you read the other sections in the manual.
Quick Startup uses static IP addresses for the purpose of simplicity, even though the CCU and
EUM support DHCP relay.
2.1
Equipment
As a minimum, the Quick Startup requires the following equipment:
one
CCU kit, consisting of
•
•
•
one
EUM kit, consisting of
•
•
•
one
PC, equipped with terminal emulation software such as HyperTerminal and an
Ethernet network interface card
one
WaveRider indoor antenna, complete with mounting bracket and RF cable
one
Straight-through RS-232 serial cable, DB-9 male to DB-9 female
APCD-LM043-4.0
CCU
CCU power supply and cable
CCU setup antenna
EUM
EUM power supply and cable
3m CAT5 crossover Ethernet cable
5