9 Installing the EUM
9.4.7 Mounting the Antenna
The antenna bracket is designed to accommodate the RF cable and act as a strain relief.
To Mount the Antenna
1. Thread the attached antenna cable through the guides in the back of the antenna
bracket, as necessary.
NOTE:
The EUM kit includes suction cups, drywall plugs, and screws to allow a variety of
mounting options:
Table 22 Antenna Mount Guidelines
Mounting Method
Suction Cups
Drywall Plugs
Screws
2. Insert the suction cups or screws into the base of the antenna bracket, then mount the
bracket onto the desired surface.
NOTE:
112
Figure 43
Rear View of Antenna Bracket
Bending the antenna cable too sharply can degrade EUM
performance. Never allow less than a 1.25 cm (0.5 in.) bend
radius. If a quarter (25-cent piece) fits into the curve, the bend is
acceptable.
Use on flat, smooth surfaces, such as glass, plastic,
laminates or metal. Remove all grease, oil, and grit
before securing the antenna bracket with suction
cups.
Use on all commercial drywall and other plaster
surfaces.
Use on hardwood surfaces.
If you mount your antenna bracket on a vertical surface, orient
the bracket so that the spring clip is closest to the ceiling.
Antenna Cable
Bracket Guides
Antenna Bracket
Guidelines
APCD-LM043-4.0