Connecting The End-User's Pc; Figure 46 Connecting The End-User's Pc; Table 24 Ethernet Led Status Displays - WaveRider LMS4000 User Manual

9.4.8 Connecting the End-user's PC

1. Connect the end-user's PC, shown in
cable that is included with the kit between the Ethernet port on the end-user's
computer and the Ethernet port on the EUM.
2. Check the Ethernet LEDs on the back panel of the EUM to ensure the Ethernet
connection between the EUM and the end-user's PC is active. Refer to
explanation of the Ethernet LED status displays.

Table 24 Ethernet LED Status Displays

Ethernet Link LED
Ethernet Traffic LED
3. When attempting to send data to, or receive data from, the Internet, check the
Ethernet Traffic LED to ensure data transmission is taking place. This LED flashes as
data traffic passes between the end-user's PC and the EUM. The network LED on the
front of the EUM also flashes and is more accessible than the Traffic LED on the rear
of the EUM.
APCD-LM043-4.0
omputer
Step 4
Ethernet Cable
4
Step 3
AC Cable
Power Bar
AC/DC Adapter
Figure 46 Connecting the End-user's PC
Ethernet LED
Figure 46, by attaching the crossover Ethernet
Bracket
Step 1
Antenna Cable
4
2
1
EUM
Step 2
DC Cable
Denotes reserved ports. Do NOT Connect.
Status
This LED is lit when there is a correct connection to
the computer, and both ends are powered ON.
Flashes when data passes through the Ethernet
connection in either direction.
9 Installing the EUM
Antenna
Antenna
Connector
Ethernet
Connector
DC Power
Connector
Table 24 for an
115