Setting The Eum Password; Configuring The Eum Rf Parameters - WaveRider LMS4000 User Manual

8 Configuring the EUM
8.1

Setting the EUM Password

To Change the EUM Password
1. Type password and press Enter.
2. At the Enter Current Password prompt, type the old password.
3. At the Enter New Password prompt, type the new password.
4. At the Verify password prompt, type the new password again.
The system displays a message that your password has been successfully changed.
Example:
Console> password
Enter Current Password: ********
Enter New Password: ********
Verify password: ********
Saving new password
Password Changed
Console>
8.2

Configuring the EUM RF Parameters

To set the EUM Operating Frequency
1. Type radio frequency <frequency> and press Enter.
•
2. Type save or commit and press Enter.
3. Before the new radio frequency will take effect, you must reboot the EUM by typing
reset and pressing Enter.
To set the EUM Power Level
1. Type radio rf <power level> and press Enter.
•
98
TIP: Passwords are alphanumeric and case-sensitive. For
example, "abc" is not the same as "aBc".
CAUTION: Remember to record the password. Unlocking the
EUM can only be performed by contacting WaveRider Technical
Support.
<frequency> is the EUM operating frequency in tenths of a MHz. For
example, 917.0 MHz is entered as 9170.
<power level> is the EUM transmit power level, either high (+26 dBm) or
low (+15 dBm). In most cases, the EUM power level should be set to high.
APCD-LM043-4.0