Conducting A Preliminary Check Of The Eum; Figure 40 Connect The Ac Power Cord; Figure 41 Eum Leds - WaveRider LMS4000 User Manual

9 Installing the EUM
NOTE:
The EUM uses a custom antenna cable and connector. If you
need to extend this cable, contact WaveRider.
3. Connect the AC power cord between the AC/DC adaptor and either an AC power bar
(preferred) or AC outlet
not have an ON/OFF switch.
NOTE: To avoid potential damage to the EUM components in the event
Power Bar

9.4.5 Conducting a Preliminary Check of the EUM

Check the LED indicators on the front of the modem to ensure that the EUM is functioning
properly.
Ethernet Link LED
Ethernet Traffic LED
To Verify Proper EUM Function
• Check that the Power LED is ON. It takes about 7 or 8 seconds to come on after you
have plugged in the unit.
110
The DC power cable features a secure locking connector. To
disconnect the cable, pull the collar back on the connector, then
continue pulling to detach the DC power cable from the EUM.
(Figure
of a power surge, WaveRider recommends using a power bar
with surge protection (instead of connecting the AC power cord
directly to an AC outlet).
AC Power Cable
Figure 40 Connect the AC Power Cord
Back Panel
Figure 41
40). The EUM immediately powers up since it does
AC/DC Adaptor
Front Panel
EUM LEDs
Network LED
Radio LED
Power LED
APCD-LM043-4.0