WaveRider LMS4000 User Manual page 195

Command Syntax (EUM)
radio rc
radio rf high|low
radio rh
radio rssi
reg eum
reset|reboot
save|commit
snmp
snmp community
snmp community add <community>
<read|write>
snmp community delete
<community>
snmp contact
snmp contact <contact>
snmp interface
snmp location
snmp location <location>
snmp trap
APCD-LM043-4.0
Command Description
Clears the CCU RSSI and transmit power
level history.
Displays or sets the power of the EUM
radio. Note: The EUM RF level should
always be set to high.
Displays the RSSI and transmit power level
history.
Displays continuous RSSI readings. Press
any key to halt.
Forces the EUM to request registration.
Reboots the EUM.
Saves configuration changes.
Displays the EUM SNMP information.
Displays the SNMP communities.
Adds an SNMP community, where.
• <community> is the name of the
SNMP community being added, from 1-
32 characters in length.
• Enter <read> or <write> to indicate
the type of the community being added.
Deletes an SNMP community, where.
• <community> is the name of the
SNMP community being deleted.
Displays the SNMP system contact.
Changes the SNMP system contact, where:
• <contact> is name of the EUM SNMP
system contact (subscriber, for
example), from 1-80 characters in
length.
Displays the interface MIBs.
Displays the SNMP system location.
Changes the SNMP system location, where:
• <location> is the location of the
EUM, from 1-80 characters in length.
Displays the SNMP Trap Server Table.
177