Eum Configuration; Figure 2 Quick Startup - Eum Configuration - WaveRider LMS4000 User Manual

2 Quick Startup
2.4

EUM Configuration

1. Connect the PC to the console port of the EUM, as shown in
CCU power
supply
2. Start the terminal emulation software.
3. Type the following commands to configure the EUM:
WaveRider Communications, Inc. LMS3000
Password:
Console> ip ethernet 10.0.0.2 22
Console> ip gateway 10.0.0.1
Console>
Console> radio frequency 9150
Console>
Console> save
Basic Config saved
Port Filter Config saved
sntp cfg file saved
Console>
4. Reboot the EUM for the settings to take effect.
Console> reset
rebooting EUM ...
(... Power On Self Test ...)
WaveRider Communications, Inc. LMS3000
Password:
8
CCU set-up
antenna
Radio
Link
CCU3000
Figure 2 Quick Startup — EUM Configuration
1
RS232 cable
EUM3000
EUM Antenna
Figure 2.
EUM Power Supply
APCD-LM043-4.0