Command Syntax (CCU)
radio frequency
radio frequency <frequency>
radio meter
radio rc
radio rf high|low
radio rh
radio rssi
rcf
reset|reboot
route
route add <aaa.bbb.ccc.ddd>
<eee.fff.ggg.hhh> (0-32)
APCD-LM043-4.0
Command Description
Displays the CCU radio frequency in tenths
of a MHz; for example, 905.0 MHz is
displayed as 9050.
Changes the CCU radio frequency, where.
• <frequency> is the new radio
frequency, in tenths of a MHz; for
example, 905.0 MHz is entered as
9050.
Displays the current Polling MAC load. This
information is displayed for each GOS.
Clears the CCU RSSI and transmit power
level history.
Displays or sets the power of the CCU radio.
Note: The CCU RF level should always be
set to high.
Displays the RSSI and transmit power level
history.
Displays continuous RSSI readings. Press
any key to halt.
Displays the contents of the route
configuration file (RCF).
Reboots the CCU.
Displays the routing table for the CCU.
Adds a route to the routing table. This
command applies only to the CCU.
• <aaa.bbb.ccc.ddd> is the Ethernet
IP address of the network being added
to the routing table.
• <eee.fff.ggg.hhh> is the Ethernet
IP address of the gateway through
which the destination is reached.
• (0-32) is the netmask for the
destination network.
169