MINN KOTA ULTREX Installation Instructions Manual page 18

ORIENTATE THE PEDAL CONTROL SLEEvE ASSEMBLY FOR A STARBOARD MOUNT
7
j. Secure the Cable Anchor to the inboard side
of the Steering Module by loosely securing the
screws in place using a #2 Phillips screwdriver.
k. Once the Cable Anchor is secured, finish prying
the Wrap Drum straight up, off of the Cable Gear
until the Wrap Drum is free of the Cable Gear.
CAUTION
Care must be taken so that the Steering Cables remain
on the Wrap Drum when it is disengaged from the Cable
Gear. It is important that the Steering Cables follow the
grooves on the Wrap Drum so that they do not become
intertwined or pop off. Be sure that the electric wire is
not damaged as the Wrap Drum is lifted.
8
l. While holding the Wrap Drum just above the
Cable Gear, and maintaining tension on the
Steering Cables, carefully rotate the Wrap Drum
right or left until the top of the Foot Pedal is
parallel with the deck of the boat. The proper
position of the Wrap Drum will locate the anchors
for each of the Steering Cables equidistant from
the mid-line of the Cable Anchor where it is
secured to the Steering Module.
CAUTION
Do not make this adjustment by applying pressure to the
Foot Pedal. Rotate the Wrap Drum manually and use
the Foot Pedal position as a guide to indicate the proper
position of the Wrap Drum.
m. Once the Foot Pedal is at the desired position,
align the Wrap Drum with the nearest tooth on
the splined shaft of the Cable Gear. Press the
Wrap Drum securely down so that it is seated on
top of the Cable Gear.
18 | minnkotamotors.com
7j
7k
Wrap Drum
Flat
Screwdriver
Cable Gear
Steering
Module
Steering
Cables
Cable
Anchor
Screws
Steering
Module
Cable Anchor
Steering
Cables
Cable Anchor
Steering Motor
Connection Wire
Wrap Drum
Cable Gear
Foot Pedal
©2016 Johnson Outdoors Marine Electronics, Inc.