MINN KOTA ULTREX Installation Instructions Manual page 17

ORIENTATE THE PEDAL CONTROL SLEEvE ASSEMBLY FOR A STARBOARD MOUNT
5
g. The Cable Anchor functions to hold the Steering
Cables in place. The cables run from the Cable
Anchor and wrap around the Wrap Drum. The
Cable Anchor is secured to the Steering Module
with two screws. Remove the two #10-32 x 1/2"
screws that hold the Cable Anchor in place using
a #2 Phillips screwdriver.
h. The Wrap Drum is set on the shaft of the Cable
Gear that extends above the Steering Module.
The female end of the electric wire passes out the
top of the Cable Gear. The shaft of the gear that
the Wrap Drum sits on is splined. To rotate the
Pedal Control Sleeve Assembly, the Wrap Drum
needs to be lifted off of the Cable Gear. Before
the Wrap Drum can be lifted or aligned, the
Steering Cables should be loosened.
6
i. Once the Cable Tension Screw is loosened,
and the screws are removed, carefully pry the
Wrap Drum partially off by prying straight up,
using a heavy flat-blade screwdriver. The Wrap
Drum should only be lifted far enough up on the
Cable Gear to rotate the Pedal Control Sleeve
Assembly to the inboard or desired position. The
Cable Anchor is in the correct position on the
mount when it is mounted towards the inboard
side of the mount.
CAUTION
Only pry the Wrap Drum high enough on the Cable Gear
to rotate the Cable Anchor and Pedal Control Sleeve
Assembly to the correct position. If the Wrap Drum
becomes unintentionally disengaged from the Cable
Gear, the Steering Cables can become unwound and will
need to be reassembled correctly for proper operation.
NOTE: The top of the Wrap Drum has rounded
and smooth edges. The bottom of the Wrap Drum
is flat and the teeth that engage the Cable Gear
are visible in the center.
©2016 Johnson Outdoors Marine Electronics, Inc.
Wrap Drum
Wrap Drum
Flat
Screwdriver
Cable Gear
Screws
Steering
Cable Anchor
Cables
Steering
Cables
Cable Anchor
minnkotamotors.com | 17